Machining for free rotation of forged rods?

[t5 pete]

Just been reading through the web and came across a post of some one needing the bottom of the bores needing machining for free rotation of the rods any one else had this issue.
Cheers

[Jamest5r]

Nope, now stop trawling the web for problems and put your engine back together :)

[t5 pete]

pmsl will do sir

[p fandango]

they do on early blocks, JT had to get it done on his

[t5 pete]

Well there will only be one answer when there fitted i will do a trial run with out fitting the goo but james had a very very very eairly block and didnt have problems i think its down to the rods people use the bloke i read about used ths rods

[claymore]

I think it also depends on what make of rods you get.

[MoleT-5R]

Well there will only be one answer when there fitted i will do a trial run with out fitting the goo but james had a very very very eairly block and didnt have problems i think its down to the rods people use the bloke i read about used ths rods

so if you don't mind me asking, who's rods are you using and are they the same as James's ?

[t5 pete]

Their dons rods and should be same as james so should have a good answer when im done

[t5 pete]

Heres myne
http://i595.photobucket.com/albums/tt39/t5pete/IMAG0979_zps2ea33109.jpg

[p fandango]

Well there will only be one answer when there fitted i will do a trial run with out fitting the goo but james had a very very very eairly block and didnt have problems i think its down to the rods people use the bloke i read about used ths rods
JT's was a 1994 block with Volvo RIP kit as standard

[t5 pete]

JT's was a 1994 block with Volvo RIP kit as standard

Same as james then