View Full Version : blanking plate woes
shepbomb
Sunday 26th August 2012, 18:29
Evening all
Fitted blanking plate to turbo yesterday and noticed one bolt was easier than others to remove and replace it has been playing on my mind all day so got home and decided to have a look, sure enough it looks like its been cross threaded at some point so I've just managed to get it in just beyond finger tight, will this be OK????
t5 pete
Sunday 26th August 2012, 18:56
It needs to be tight to make the seal
Jamest5r
Sunday 26th August 2012, 19:40
Is the bolt hole one of the easy ones to get to?? can tap it out an extra mil on sat for you if you get the bolt to match.
shepbomb
Sunday 26th August 2012, 21:10
Yes james its the easiest one to get to, and I will try and source a bolt this week, what size would I need to get though
t5 pete
Sunday 26th August 2012, 21:19
Yes james its the easiest one to get to, and I will try and source a bolt this week, what size would I need to get though
A bigger one than what u have lol ill bring my hammer aswell the new bolt is going in one way or another lol
shepbomb
Sunday 26th August 2012, 21:56
will it fix the mystery rattle??
t5 pete
Sunday 26th August 2012, 22:00
pmsl
Jamest5r
Sunday 26th August 2012, 23:45
Yes james its the easiest one to get to, and I will try and source a bolt this week, what size would I need to get though
Just the next mil up from the bolt used, got a tap set so will work something out.
shepbomb
Monday 27th August 2012, 16:24
Excellent cheers James will get one this week
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.