T4 Injectors for 350+bhp

[mitchyboy01]

Hi,

What uprated injectors would I need to support 350Bhp+ on my phase 1 T4? I've read on other boards that the S60R ones can be used but are these up to job?

Thanks,

Mitch.

[smithy]

Hi,

What uprated injectors would I need to support 350Bhp+ on my phase 1 T4? I've read on other boards that the S60R ones can be used but are these up to job?

Thanks,

Mitch.

put some vxr470 injectors they only run at 3 bar at 470cc the s60r ones run at 3.8 bar at 465cc and the vxrs are cheaper too

[p fandango]

put some vxr470 injectors they only run at 3 bar at 470cc the s60r ones run at 3.8 bar at 465cc and the vxrs are cheaper too
Courtney say their good for 320bhp, but as you say raise the pressure to the 3.8psi the same as the S60R & they should be able to cope easily LINK (http://www.courtenaysport.co.uk/buy-online/shop-by-category/tuning-components/vxr-injectors-set-of-4/prod_401.html)

[mitchyboy01]

That's great. Thanks for the info Pedro. Are these a direct fit?

[mitchyboy01]

Courtney say their good for 320bhp, but as you say raise the pressure to the 3.8psi the same as the S60R & they should be able to cope easily LINK (http://www.courtenaysport.co.uk/buy-online/shop-by-category/tuning-components/vxr-injectors-set-of-4/prod_401.html)

Also pedro, are these high impedance jobbies as I know the T4 injetors differ from the T5 compatible ones? thanks

[smithy]

Also pedro, are these high impedance jobbies as I know the T4 injetors differ from the T5 compatible ones? thanks

all i have to say is they are overfueling my 940 at 22 psi in 4th on the rollers at 3 bar so should do the job for you

[mitchyboy01]

all i have to say is they are overfueling my 940 at 22 psi in 4th on the rollers at 3 bar so should do the job for you

Thanks mate!

[gmain1967]

Either of these below would do the trick for you;

Ford Racing M9593-F304

Siemenes Deka 610 (Mototron 10796)

I have Bosch parts 0280 150 558 on mine now which are supposed to be OK to around that power, but will run near their maximum duty cycle.

[Al115]

RC injectors are another possibility.