fitted the blitz sbc today

[t5 pete]

Well after seeing where other people had fitted theres i wanted to do it my self so heres how its turned out.
It was a swine to do as i wanted to keep the little air deflectors and also have the vent tilted a little so it was facing me not the seat.
Just carnt wait now to set it up.
http://i595.photobucket.com/albums/tt39/t5pete/IMAG0172.jpg

[M-R-P]

Tidy job there Pete. Like the boost gauge too.
:)

[antz]

that looks ace!

[Jamest5r]

That's very clever mate i like it :), now get that 18t spooling proper :)

[t5 pete]

That's very clever mate i like it :), now get that 18t spooling proper :)


Tell me about it im certainly going to see what it can do tho

[pigfight]

nice 1 pete,
very covert looking. i may have to get some fitting tips from you once i recieve mine off emlyn

[t5 pete]

yeah no problem there quite easy to fit just give me a shout and ill giude you through it.

[pigfight]

nice 1 pete,
very covert looking. i may have to get some fitting tips from you once i recieve mine off emlyn :rolleyes:



(im fkn useless at this editing and smiley business!!!!)

[LiamT4]

Would having the heaters on, eventually, cause problems when they are fitted there?

Does look good fitted there though.

[t5 pete]

Would having the heaters on, eventually, cause problems when they are fitted there?

Does look good fitted there though.

i doubt it very much liam as half of the vent is still open so the heat can escape not causing a blockage

[theflyingbrick]

where did you get the pillar mount from ive been looking but can only find universal ones!!! and the previous owner has mounted the boost gauge in the heater vent,besides the fact its a stupid plae to put it being quite tall i cant actually see the gauge properly :(

[t5 pete]

I made it my self it used to be a pillar pod but then cutting and chopping etc and made it look alittle more stock

[theflyingbrick]

I made it my self it used to be a pillar pod but then cutting and chopping etc and made it look alittle more stock

blimey you done a good job there mate it looks like a factory made one for volvos!! ok i accept the challenge and will try a universal one and chop it up, and see if comes out as good as yours ;)

[T4Rick]

I really like the gauge holder as well mate