adjusting my mbc

[stevie69]

silly question i know but do you screw the bolt on a mbc in or out to lower the boost?mine is maybe a bit on the high side and iv forgot..

[p fandango]

silly question i know but do you screw the bolt on a mbc in or out to lower the boost?mine is maybe a bit on the high side and iv forgot..
to lower the boost you undo it, turn it anticlockwise. That eases the pressure on the spring which is holding the ball bearing/washer that stops the boost getting to the actuator

[stevie69]

cheers.hit 1.5 bar rushing to watch the darts tonight and im sure i felt a wee miss..

[p fandango]

cheers.hit 1.5 bar rushing to watch the darts tonight and im sure i felt a wee miss..
i guess your remapped as well then?

[stevie69]

yip.have had the 2 on for a couple of years now.i was always pretty dissapointed with them till yosser gave me another actuator now its better.its bone dry here and it was spinning in 3rd.will i get away with leaving it where it is?

[p fandango]

will i get away with leaving it where it is?
i used to run mine at 20.8psi, but it is high & no real benefit running that high with our small turbos so i would turn it down especially if you felt a miss

[stevie69]

ill turn it down tommorow.thanks again..

[p fandango]

ill turn it down tommorow.thanks again..
no problem sir