Off to Braydons in the morning,

[siamblue]

My beloved is off to Braydons tomorrow, Booked in for 8.30 am,
Will be getting another fob reprogrammed £25, Plus my aircon codes read even though now the climate is blowing cold air and the amber lights haven't been on for a month now typical huh,
A question i want to ask is i am more than likely get him to test the actuator pressure, Now someone said adjust it upto 6psi but not above 8psi, Why the difference in 2 psi ? As this will be a +25 % pressure if i adjust it to 8 instead of 6psi,
Will report back tomorrow....

Gary

[Wobbly Dave]

Standard actuator pressure is 4psi - no more no less.

[siamblue]

Well that was lucky then because they didn't have a gauge,
Got the aircon all done only had 50 grams of R143a in it, Plus 3 temp air con codes, One the resistor,2 The inside temp sensor, 3,Some other sensor,
It's like sitting in a freezer now lol too cold with the temps outside at 24 deg C here in London,Had it leak tested and with new oil and refridge,
Managed to get a space saver too, So all set for Saturday now yipee. :B_steerin
Bloody key fob didn't programme, To anyone out there S/V40 and S/V/C70 are different frequency's so only buy for you current Model in this country.

Gary.

[Justin]

Standard actuator pressure is 4psi - no more no less.
Its 4.5psi actually wobbly ;)