PDA

View Full Version : Idle Speed


cornclose
Thursday 14th May 2009, 13:10
On a phase 2 V70 T5, with geartronic box if that makes a difference, what should the idle speed be (fully warm of course) ?
dave stew
Thursday 14th May 2009, 13:36
Don't know for definite - guessing about 800RPM.

But then Rome wasn't built on guesswork!
richiemat
Thursday 14th May 2009, 13:36
About 800-850rpm i think
cornclose
Thursday 14th May 2009, 13:49
Can you guys all check this for me the next time you're in your cars please ? The more the merrier!
richiemat
Thursday 14th May 2009, 13:52
Can you guys all check this for me the next time you're in your cars please ? The more the merrier!

tell us yours first:doctor:
cornclose
Thursday 14th May 2009, 13:56
Mine's at around 750, give or take, I reckon it's too low....
t5owner
Thursday 14th May 2009, 14:13
My P2 explod idles at a steady 800 rpm on the button mate

Cheers

stuart
kyebosh
Thursday 14th May 2009, 15:06
Mines bang on 800 rpm
cornclose
Friday 15th May 2009, 08:38
Right, mine is 700-750 rpm according to the car's tacho. I'll check it with OBDII aswell. I think it's too low.

I presume the idle speed is controlled by the ECU and has a setpoint which can be changed ? Anyone know how to change it ?
bornagain
Sunday 17th May 2009, 09:04
On my S60 T5 it's 790rpm
PaulZX
Sunday 17th May 2009, 16:00
you can adjust the baseline tickover from the throttle housing....
cornclose
Sunday 17th May 2009, 18:00
Thanks, but can this be done on phase 2 (ME7) engines ? If so, can you provide more details ?
PaulZX
Sunday 17th May 2009, 21:49
Thanks, but can this be done on phase 2 (ME7) engines ? If so, can you provide more details ?

I dunno but the volvo 960 has the exact same adjusting screw in the same place as the one on the 1996 850 throttle housing, so possibly. It's a little 6mm ish locknut and screw jobby near the spring that returns the butterfly to closed. I can take a pic of mine, so you can compare, if you want....
thebadger
Monday 18th May 2009, 20:59
My car had a 1000tick over till I replaced the maf.
cornclose
Tuesday 19th May 2009, 15:21
Thanks chaps. Still can't see any way to adjust the tickover on my throttle module. Me thinks this is a software only setting...
bowman
Tuesday 19th May 2009, 21:07
Do autos not tickover slightly lower to reduce creeping?

my new one sits perfectly between the 600 and 700 marks, cant be anymore accurate as the needle is the width of the gap in the marks!

I would'nt be concerned mate, if it feels and sounds happy....
cornclose
Wednesday 20th May 2009, 09:55
Not sure about autos being slightly lower - maybe.

It does occassionally feel a little lumpy at idle though, so was wondering what the correct setting should be.