PDA

View Full Version : wheel bearing


stevie69
Sunday 29th March 2009, 11:48
does anybody have a drivers side front wheel bearing they want to sell?mine is starting to whine and i cant afford a new one right now..
siamblue
Sunday 29th March 2009, 13:35
I have one from a V70 T5 if they are the same?

Gary
stevie69
Sunday 29th March 2009, 13:44
iv no idea.someone will probably know.thanks tho.
AlanG
Sunday 29th March 2009, 14:21
Be very careful my friend. Not sure what you're driving but I do know from experience there are 5 different bearings for the 850. Think only one for the old 4 stud setup. There are 4 for the 5 bolt setup. You'll need your chassis no. Comes with the hub as a complete unit and from my friendly motor factor at mate's rates,it still cost £125.You'll need a new nylock hubnut that didn't come with mine. Only good news is that the job itself is not difficult. Hope this helps........
5seaterT5x2
Sunday 29th March 2009, 17:34
Be very careful my friend. Not sure what you're driving but I do know from experience there are 5 different bearings for the 850. Think only one for the old 4 stud setup. There are 4 for the 5 bolt setup. You'll need your chassis no. Comes with the hub as a complete unit and from my friendly motor factor at mate's rates,it still cost £125.You'll need a new nylock hubnut that didn't come with mine. Only good news is that the job itself is not difficult. Hope this helps........

£125? blimey that was for genuine i hope?
did mine the other week got bits from euro parts bout £50/60 i seem to remember and it came with new centre nut. Not a terrible job to do
AlanG
Sunday 29th March 2009, 17:49
Should be a lot cheaper now. Sorry,should've said this was about 4 years ago. Doh!! My main point really was that getting the correct one can be pain in the a**e!!
spesh
Sunday 29th March 2009, 19:46
i just done the front pair on my v70, got them from GSF for £140 with vat and 2 hub nuts, they only listed one for the 5 stud.
AlanG
Sunday 29th March 2009, 19:58
Nice one mate,it's possible the final 850 model has the same bearing as the S/V models. Mine was a late '96 P. There were definitely 5 for the 850 though.
Saaamon
Monday 30th March 2009, 19:49
Nice one mate,it's possible the final 850 model has the same bearing as the S/V models. Mine was a late '96 P. There were definitely 5 for the 850 though.

I'm sure i've seen a couple different hubs in 5 spoke pattern for these.